Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
PERFORM ECM RECOMMUNICATING FUNCTION
Install ECM.
Contact backside of the registered Intelligent Key* to push-button ignition switch while push switch is pressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
Maintain ignition switch in the ON position for at least 5 seconds.
Ignition switch OFF.
Check that the engine starts.
GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Refer to Description.
>>END
Additional Service When Replacing Ecm
Performing the following procedure can automatically activate recommunication of ECM and Intelligent Key unit, but only when the ECM is replaced with a new one*. For details, refer to Work Procedure.
...
Other materials:
Draining
WARNING:
IN CASE REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
Regarding brake fluid draining, refer to Work Procedure.
IN CASE NOT REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
CAUTION:
Connect a vinyl tube to the bleed valve.
Depress the brake pedal and ...
Anchoring by Rigid Racks and Chains
Place the frame on rigid racks and pull the high strength/rigidity portions with chains. Thus, secure the frame tightly in the vertical direction. The rigid racks sustain the frame from below and the tensioned chains restrict any upward movement.
The figure shows a typical anchoring method.
This me ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision.
Information necessary to service the system safely is includ ...
0.0052