WARNING:
IN CASE REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
Regarding brake fluid draining, refer to Work Procedure.
IN CASE NOT REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
CAUTION:
Connect a vinyl tube to the bleed valve.

Depress the brake pedal and loosen the bleeder valve to gradually discharge brake fluid.
Inspection
RefillingRemoval and Installation
REMOVAL
Remove the back door finisher. Refer to Removal and Installation.
Remove the rear camera mounting screws , then remove the rear camera .
INSTALLATION
Install in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure.
Perform camera imag ...
Tracking Gauge and Steel Tape
Measure the distance between two points. Before using the tracking gauge, check the measuring points with the steel tape.
(1) TRACKING GAUGE
Fit the tracking gauge correctly to the measuring point.
The dimension is indicated between the hole center.
If measurement is unavailable, use the method sho ...
Removal and Installation
REMOVAL
Remove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect back door auto closure control unit harness connector.
Remove back door auto closure control unit mounting nuts , and then remove back door auto closure control unit .
INSTALLATION
Install in the reverse o ...