Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
PERFORM SYSTEM INITIALIZATION
Close moonroof and sunshade.
Press and hold the moonroof switch CLOSE for approximately 10 seconds.
Moonroof and sunshade will move as following.
Moonroof tilt up, and the sunshade slightly close and stops.
Release the moonroof switch, and continue to press the moonroof switch CLOSE again soon.
Moonroof and sunshade will move as following.
Sunshade fully open → moonroof tilt down → moonroof fully open → moonroof fully closed → sunshade fully closed.
Release the moonroof switch after moonroof and sunshade stopped.
GO TO 2.
CHECK THE FUNCTION
Check that moonroof and sunshade automatically operated normally.
Check anti-pinch function. Refer to Description.
END
System Initialization
Initialization of system should be conducted after the following conditions. Refer to Work Procedure.
When the moonroof motor assembly or sunshade motor assembly is replaced.
When the moonroof or suns ...
Anti-Pinch Inspection
Check anti-pinch function when the initialization of moonroof and sunshade system is performed. Refer to Work Procedure. ...
Other materials:
Removal and Installation
CAUTION:
Always work with 2 workers, because it is heavy weight.
REMOVAL
Disengage fixing pawls, and then remove seat leg covers.
: Pawl
Remove front side mounting bolts of third seat assembly.
Remove luggage floor bracket. Refer to Removal and Installation.
Remove third seat belt buckle. Ref ...
Diagnosis Procedure
CHECK SYMPTOM
Check that the vehicle jerks when VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function operates.
...
Inspection
INSPECTION AFTER REMOVAL
Appearance
Propeller Shaft Runout
Propeller shaft runout : Refer to Propeller Shaft Tube.
Journal Axial Play
Journal axial play : Refer to Journal.
Joint Flex Torque
Joint flex torque : Refer to Journal.
Center Bearing
Check center bearing for noise and damage. ...
0.0065