Nissan Armada 2025-2026 Service and Repair Manual: System Initialization
Initialization of system should be conducted after the following conditions. Refer to Work Procedure.
When the moonroof motor assembly or sunshade motor assembly is replaced.
When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK DTC
Check DTC.
Perform the following procedure ...
Work Procedure
PERFORM SYSTEM INITIALIZATION
Close moonroof and sunshade.
Press and hold the moonroof switch CLOSE for approximately 10 seconds.
Moonroof and sunshade will move as following.
Moonroof tilt up, and th ...
Other materials:
Removal and Installation
REMOVAL
Remove combination meter. Refer to Removal and Installation.
Remove mounting screw , and remove bracket .
Remove mounting nuts , and remove ADAS control unit 2 from steering member .
Disconnect ADAS control unit 2 connector.
Remove mounting nuts , and remove ADAS control unit 2 from br ...
NVH Troubleshooting Chart
Possible cause and suspected parts SYMPTOM Reference Noise Shake Vibration Shimmy Judder Poor quality ride or handling Improper installation, looseness × × × × × × REAR SHOCK ABSORBER: Exploded View
FRONT LOWER LINK: Exploded View
REAR LOWER LINK AND COIL SPRING: Exploded View
...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
0.0068