CAUTION:
When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "Initialization position adjustment" of "Work support". Refer to Work Procedure.
×: Required —: not required
| Procedure | Initialization position adjustment |
|---|---|
| Removing/ installing ABS actuator and electric unit (control unit) | — |
| Replacing ABS actuator and electric unit (control unit) | × |
| Removing/ installing rear brake pad (When not pressing piston of rear brake caliper assembly) | — |
| Removing/ installing rear brake pad (When pressing piston of rear brake caliper assembly) | — |
| Replacing rear brake pad | × |
| Removing/ installing rear brake caliper assembly | — |
| Replacing rear brake caliper assembly | × |
| Removing/ installing parking brake switch | — |
| Replacing parking brake switch | — |
Work Procedure
Work ProcedureRemoval and Installation
WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove glove box cover. Refer to Removal and Installation.
Disconnect transfer control unit harness connector.
INSTALLATION ...
Exploded View
Air inlet tube 1 Bracket 1 Mounting rubber (upper) Bracket 2 Charge air cooler cover Clip Mounting rubber (lower) Bracket 3 Bracket 4 Air inlet tube 2 Air inlet hose Clamp Recirculation valve Turbocharger boost sensor Charge air cooler To electric throttle control actuator. Refer to ...
I-BSI system operation
Example
Side indicator light
I-BSI ON indicator (vehicle information display)
I-BSI indicator (vehicle information display)
ProPILOT Assist switch (design may vary depending on Nissan Armada model)
The Nissan Armada I-BSI system becomes active at speeds above approximately 37
MPH ...