Zero point reset is an initializing procedure for occupant detection system that must be performed when replacing occupant detection system control unit or removing and installing passenger seat.
If zero point reset is not performed, the initialization is incomplete and occupant detection system does not operate normally. Refer to Work Procedure.
NOTE:
When replacing passenger seat with a NISSAN genuine part, SRS air bag warning lamp turns ON if zero point reset is incomplete.
When zero point reset is performed once after removal and installation of passenger seat, CONSULT displays “Already performed” and SRS air bag warning lamp does not ON.
When reinstalling passenger seat after removal, the initial value for occupant detection system sensor changes, and occupant detection system does not operate normally.
Always perform zero point reset after performing the work as per the following.
Reinstallation of passenger seat
Replacement of passenger seat with a seat that is zero point reset complete.
Work Procedure
Work ProcedureRemoval and Installation
REMOVAL
Radiator Air Guide Upper
Remove front grille upper. Refer to Removal and Installation (OFF ROAD MODELS) or Removal and Installation (CITY MODELS).
Remove radiator air guide upper fixing clips, and then remove radiator air guide upper.
Radiator Air Guide RH
Remove front bumper fascia. Refer t ...
Exploded View
ABS actuator and electric unit (control unit) Bracket ABS actuator and electric unit (control unit) harness connector To electrical brake control unit primary side To electrical brake control unit secondary side To front RH caliper To front LH caliper To rear RH caliper To rear LH caliper ...
MOD system limitations
WARNING
The following section outlines important limitations of the Moving Object
Detection (MOD) system in the Nissan Armada. Ignoring these limitations or relying
on the system beyond its capabilities may significantly increase the risk of accidents,
serious injury, or even fatal outcomes. ...