Description
Each function is reset to the following condition when the driver seat control unit is replaced. For details, refer to Work Procedure.
| Function | Condition | Procedure |
|---|---|---|
| Memory (Seat, steering column, door mirror) | Erased | Perform memory storing |
| Log-in | Erased | Perform log-in storing |
Work Procedure
REPLACE DRIVER SEAT CONTROL UNIT
Replace driver seat control unit. Refer to Removal and Installation.
>>
GO TO 2.
vehicle SPECIFICATION RECOGNITION
Connect battery negative terminal. Power switch ON and wait for 30 seconds or more.
NOTE:
When the driver seat control unit receives a signal from the AV control unit for 30 seconds after the battery is energized, it is recognized and set as the specifications of with navigation system.
>>
GO TO 3.
LOG-IN STORING
Perform log-in storing. Refer to System Description.
>>
GO TO 4.
MEMORY STORING
Perform memory storing. Refer to Description.
>>
WORK END
Other materials
Transfer: Atx93a Tools and Preparation
Preparation
Commercial Service Tools
Tool name Description
Drift
a: 61.0 mm (2.402 in) dia.
b: 56.3 mm (2.217 in) dia.
Installing front oil seal
Drift
a: 66.3 mm (2.610 in) dia.
b: 61.9 mm (2.437 in) dia.
Installing rear oil seal
Drift
a: 68.6 mm (2.701 in) dia.
b: 58.0 mm (2.28 ...
Diagnosis and Repair Work Flow
Work Flow
DETAILS OF TROUBLE DIAGNOSIS FLOWCHARTCOLLECT THE INFORMATION FROM THE CUSTOMER
It is also important to clarify customer concerns before starting the inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce the symptom as well as fully understand it. Dep ...
Automatic Back Door Anti-Pinch Function Does Not Operate
Diagnosis Procedure
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT
Check that DTC is not detected with automatic back door control unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK TOUCH SENSOR LH
Check touch sensor LH.
Refer to DTC Diagnosis Procedu ...