Description
After replaced A/C auto amp. it is necessary to perform control unit configuration with CONSULT. For details, refer to Work Procedure.
AFTER REPLACEMENT
CAUTION:
-
When replacing A/C auto amp. write vehicle specification with CONSULT vehicle configuration.
-
Never perform vehicle configuration other than performing with new A/C auto amp. or the control function may not operate normally.
Work Procedure
REPLACE A/C AUTO AMP.
Replace A/C auto amp. Refer to Removal and Installation.
>>
GO TO 2.
WRITING vehicle SPECIFICATION
Perform configuration (HVAC). Refer to Description.
>>
WORK END
Other materials
Rear Height Sensor
Exploded View
Rear height sensor
:vehicle front
:N·m (kg-m, ft-lb)
:N·m (kg-m, in-lb)
Removal and Installation
REMOVALWARNING:
When removing the air suspension component parts, always follow the removing procedure since the vehicle heigh ...
Vdc Warning Lamp, Abs Warning Lamp and Brake Warning Lamp Turn on
Description
ABS warning lamp and Brake warning lamp turn ON for a moment when restating the engine.
Diagnosis Procedure
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT
Start the engine.
CAUTION:
The vehicle must be in a stopped state.
Connect booster battery (12V) and jumper cab ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...