NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Around View Monitor Control Unit

Nissan Armada 2025-2026 Service and Repair Manual / Driver Information & Multimedia / Audio, Visual & Navigation System. Around View Monitor / Additional Service When Replacing Around View Monitor Control Unit

Description

CAUTION:

  • When replacing the around view monitor control unit, always replace it with a new one. Around view monitor system does not operate properly in case of reuse of the around view monitor control unit from another vehicle.

  • When before writing the around view monitor control unit configuration, always writing the MAC key.

Perform the following operations when replacing around view monitor control unit. For details, refer to Work Procedure.

AFTER REPLACEMENT

When after replacing around view monitor control unit, the following items must be performed. Or not doing so, around view monitor system does not operate normally.

  • Writing MAC key

  • Configuration

  • Camera calibration

Work Procedure

Perform the following procedures after replacing the around view monitor control unit.

REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to Removal and Installation.

>>

GO TO 2.

WRITING MAC KEY

With CONSULT

Perform MAC key writing. Refer to Description.

>>

GO TO 3.

PERFORM CONFIGURATION

With CONSULT

CAUTION:

When before writing the around view monitor control unit configuration, always writing the MAC key.

Perform "Replace ECU".

>>

GO TO 4.

WRITING OF CALIBRATION DATA

Write the calibration data stored in the camera using CONSULT. Refer to Work Procedure.

NOTE:

When the vehicle image can be rotated by swiping in 3D View, choose "3D View Rotate" If rotation is not possible, choose "3D Fixed View."

>>

GO TO 5.

PERFORM SELF-DIAGNOSIS

  1. Perform the self-diagnosis of around view monitor control unit with CONSULT (AROUND VIEW MONITOR).

  2. Check if any DTC is detected.

Is any DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.

NO>>

GO TO 6.

OPERATION CHECK

Confirm that the operation of the around view monitor and the camera image (reference line, expected route) are normal.

>>

WORK END

    Other materials

    RAB system limitations
    WARNING The following limitations apply to the Rear Automatic Braking (RAB) system in the Nissan Armada. Failure to fully understand and follow these limitations may result in serious injury or even fatal accidents. When the Nissan Armada approaches an obstacle while the accelerator or b ...

    Hood Hinge
    Removal and Installation REMOVALRemove hood assembly. Refer to Removal and Installation. Remove front fender assembly. Refer to Removal and Installation. Remove hood hinge mounting bolts, and then remove hood hinge.INSTALLATIONNote the following items, and then install in the reverse order of remova ...

    Display Unit Symptoms
    Symptom Table Symptom Reference TELLTALE DOES NOT LAMP WHEN IGNITION SWITCH IS OFF TO ON Refer to Diagnosis Procedure. DISPLAY SCREEN IS NOT DISPLAYED (INFORMATION DISPLAY) Refer to Diagnosis Procedure. ...