Removal and Installation
REMOVAL
Remove hood assembly. Refer to Removal and Installation.
Remove front fender assembly. Refer to Removal and Installation.
Remove hood hinge mounting bolts, and then remove hood hinge.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Before installation, apply anticorrosive agent onto mounting surface.
-
Before installation, check the hood hinge rotating part for poor lubrication. Refer to Inspection.
-
When installation, perform the fitting adjustment. Refer to Adjustment.
-
After installation, apply touch-up paint (the body color) if the paint around hinge is peeled off during removal.
-
After installation, check the open/close operation. Refer to Inspection.
Other materials
Push-button ignition switch operation
CAUTION
Avoid leaving your Nissan Armada with the ignition switch in the ON position
while the engine is not running for extended periods, as this can drain the
battery.
Use electrical accessories in your Nissan Armada primarily when the engine
is running. If accessories must be used ...
Led Headlamp Operation Inspection
Work Procedure
CHECK START
In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable s ...
Telltale Does Not Lamp When Ignition Switch Is Off to on
Diagnosis Procedure
CHECK TELLTALE (BULB CHECK)
Check the telltale "BULB CHECK" below.
TelltaleRefer to "BULB CHECK"
ABS warning lamp
Refer to ABS Warning Lamp.
Brake system warning lamp
Refer to Brake System Warning Lamp.
Electronic parking brake warning lamp
Refer to Electric Parking Brake Warni ...