Description
When replacing automatic back door control unit necessary to perform initial setting to operate automatic back door system normally. Refer to Work Procedure.
Work Procedure
STEP 1
Fully close the back door manually.
>>
GO TO 2.
STEP 2
Operate back door opener switch and perform automatic back door open operation.
>>
GO TO 3.
STEP 3
-
The back door fully opens.
-
Check that automatic back door warning buzzer sounds normally.
Does automatic back door warning buzzer sound normally?
YES>>GO TO 4.
NO>>GO TO 1.
STEP 4
Fully close the back door.
>>
WORK END
Other materials
Wastegate Valve Closed Position Learning
Description
Wastegate valve closed position learning is a function of ECM to learn the fully closed position of the wastegate valve by monitoring the wastegate valve position sensor output signal. It must be performed under any of the following conditions.
Work Procedure
PERFORM WASTEGATE VALVE CLOS ...
Back Door Inner Finisher
Removal and Installation
CAUTION:
Never damage the back door panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove back door lower finisher. Refer to Removal and Installation.
Apply protective tapes (A) on back door panel to prot ...
Radiator Core Seal
Removal and Installation
REMOVALApply protective tape (A) on the part to protect it from damage.
Disengage radiator core seal fixing clips using a remover tool (A), and then remove radiator core seal .
: Clip
INSTALLATIONInstall in the reverse order of removal. ...