Work Procedure
-
Always perform the front camera unit configuration after replacing the front camera unit.
-
Always perform the camera aiming after removing and installing or replacing the front camera unit.
CAUTION:
The system does not operate normally unless the front camera unit configuration and the camera aiming adjustment are performed. Always perform them.
FRONT CAMERA UNIT CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
CAMERA AIMING ADJUSTMENT
Perform the camera aiming adjustment with CONSULT. Refer to Work Procedure.
>>
GO TO 3.
PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of front camera unit with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES>>Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.
NO>>GO TO 4.
ACTION TEST
-
Perform the following system action test.
-
LDW: Refer to Work Procedure.
-
I-LI: Refer to Work Procedure.
-
I-BSI: Refer to Work Procedure.
-
TSR: Refer to Work Procedure.
-
-
Check that the each system operates normally.
>>
WORK END
Other materials
How to use the automatic brake hold function
Basic information
For optimal use of the Nissan Armada automatic brake hold system, follow the
operational guidelines outlined below to ensure safe and effective performance.
To maintain braking force automatically
When the Nissan Armada automatic brake hold function is active and the white
i ...
Vr35ddtt
Exploded View
Transmission housing
Starter motor cover 1
Starter motor cover 2
“B” terminal harness
Starter motor harness connector
Starter motor
: vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Indicates that the part is connected at points with same s ...
Rack End Value Reset
Work Procedure
NOTE:
When steering column assembly and steering gear assembly are replaced, rack end value reset (steering wheel turning angle learning value reset) is performed.
When the toe-in is adjusted, back end value reset (steering wheel turning angle learning value reset) is performed.
...