Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Adjustment of Steering Angle Sensor Neutral Position

Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Refer to Work Procedure.

×: Required —: Not required

Procedure Adjust the neutral position of steering angle sensor
Removing/ installing ABS actuator and electric unit (control unit)
Replacing ABS actuator and electric unit (control unit) ×
Removing/installing steering angle sensor ×
Replacing steering angle sensor ×
Removing/installing steering components ×
Replacing steering components ×
Removing/installing front suspension components ×
Replacing front suspension components ×
Removing/installing tire
Replacing tire
Tire rotation
Adjusting front wheel alignment. ×
Work Procedure
WRITING VEHICLE SPECIFICATION With CONSULT Perform writing vehicle specification to ABS actuator and electric unit (control unit) following "Automatic Configuration" procedure of "Configuration" accor ...

Work Procedure
CAUTION: Always use CONSULT when adjusting the neutral position of steering angle sensor. (It cannot be adjusted other than with CONSULT.) CHECK THE VEHICLE STATUS (1) Stop vehicle with front wheels ...

Other materials:

Diagnosis Procedure
COMBINATION SWITCH INSPECTION Check combination switch. Refer to Symptom Table. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning part. CHECK POSITION LIGHT REQUEST SIGNAL With CONSULT Select “Position light request” in “Data Monitor” ...

Main Bearing
MAIN BEARING Unit: mm (in) Grade number Thickness Width Identification color Remarks 0 2.500 - 2.503 (0.0984 - 0.0985) 19.9 - 20.1 (0.783 - 0.791) Black - Black Grade is the same for upper and lower bearings. 1 2.503 - 2.506 (0.0985 - 0.0987) Brown - Brown 2 2.506 - 2.509 (0.0987 - 0. ...

Tire Pressure Monitoring System (TPMS)
Basic information For optimal safety and performance of your Nissan Armada, each tire—including the spare tire (if equipped)—should be inspected at least once a month when cold and inflated according to the manufacturer’s recommended pressure values listed on the vehicle placard or tire ...

© 2014-2026 Copyright www.niarmada.com
 
0.0066