Symptom Description
Without ProPILOT Assist 2.1
The AEB OFF warning lamp is blinking. Refer to Diagnosis Procedure.
NOTE:
When any of the following conditions, the AEB OFF warning lamp blinks:
-
The distance sensor area of the front of the vehicle is covered with dirt or is obstructed
-
The interior temperature of the vehicle is extremely high
-
The windshield is dirty, frosted, fogged up, or damaged in front of the front camera unit
-
The front camera unit or the front camera unit bracket is not mounted properly
With ProPILOT Assist 2.1
The AEB OFF warning lamp is blinking. Refer to Diagnosis Procedure.
NOTE:
When any of the following conditions, the AEB OFF warning lamp blinks:
-
The distance sensor area of the front of the vehicle is covered with dirt or is obstructed
-
The interior temperature of the vehicle is extremely high
-
The windshield is dirty, frosted, fogged up, or damaged in front of the driver assistance camera
-
The driver assistance camera or the driver assistance camera bracket is not mounted properly
Diagnosis Procedure
Without ProPILOT Assist 2.1
CHECK THE WINDSHIELD
Check if the windshield is dirty, frosted, fogged up, or damaged in front of the front camera unit.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Clear, clean, or repair the windshield as needed. Refer to Removal and Installation.
CHECK THE FRONT CAMERA UNIT AND FRONT CAMERA UNIT BRACKET INSTALL CONDITION
Check if the front camera unit and the front camera unit bracket are mounted properly.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Correct improper mounting.
With ProPILOT Assist 2.1
CHECK THE WINDSHIELD
Check if the windshield is dirty, frosted, fogged up, or damaged in front of the driver assistance camera.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Clear, clean, or repair the windshield as needed. Refer to Removal and Installation.
CHECK THE DRIVER ASSISTANCE CAMERA AND DRIVER ASSISTANCE CAMERA BRACKET INSTALL CONDITION
Check if the driver assistance camera and the driver assistance camera bracket are mounted properly.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Correct improper mounting.
Other materials
Third Seat Belt Retractor
Removal and Installation
REMOVALSeat Belt Retractor (LH and RH)Remove third seat assembly. Refer to Removal and Installation.
Remove anchor plate mounting anchor bolt .
Remove shoulder anchor.Remove back pillar garnish. Refer to Removal and Installation. Remove shoulder anchor mounting anchor bolt ...
Rear Moonroof Glass
Exploded View
Refer to Exploded View.
Removal and Installation
CAUTION:
Always work with a helper.REMOVALRemove moonroof unit assembly. Refer to Removal and Installation.
Remove rear moonroof glass fixing screws , and then remove rear moonroof glass.
Remove fixing clips, and then remove center rei ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...