Removal and Installation
REMOVAL
Remove front grille. Refer to Removal and Installation.
Disengage fixing pawl.
 |
: Pawl |
Disconnect harness connector 
to remove ambient sensor 
.
INSTALLATION
Install in the reverse order of removal.
Other materials
Rear Door Finisher
Removal and Installation
CAUTION:
Never damage rear door panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Fully open rear door.
Remove pull handle cap.Apply protective tape (A) on rear door finisher to protect it from damage.
Remo ...
Repairing Material
Foam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...
Rear Wiper Blade
Removal and Installation
REMOVALOperate rear wiper to the service position. Refer to System Description.
Lift up rear wiper arm, and then lock back rear wiper arm.
Remove rear wiper blade from rear wiper arm while rotating rear wiper blade in the direction indicated by the arrows as shown in the f ...