Removal and Installation
REMOVAL
Remove automatic back door switch finisher. Refer to Removal and Installation.
Disengage automatic back door close switch assembly fixing pawls using a remover tool (A), and then remove automatic back door close switch assembly 
from automatic back door switch finisher.
 |
: Pawl |
INSTALLATION
Install in the reverse order of removal.
Other materials
Parking Brake Does Not Release
Description
When the electric parking brake cannot be released by the parking brake switch or automatically releasing, following procedure can be released.CAUTION:
Never reuse the parking brake actuator.
When replacing parking brake actuator, replace rear brake caliper assembly.
Diagnosis Proc ...
Excessive Operation Frequency
Description
VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function operates in excessive operation frequency.
Dia ...
Center Pillar Upper Garnish
Removal and Installation
CAUTION:
Never damage the body panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove center pillar lower garnish. Refer to Removal and Installation.
Pull out tongue of seat belt pre-tensioner retractor fr ...