WARNING
Failure to properly follow the safety guidelines and operating instructions for the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system may result in serious injury or even fatal accidents.
- The Nissan Armada I-BSI system is designed as a driver assistance feature and must not replace safe driving habits. It cannot prevent all collisions. Always check mirrors, look over your shoulder, and confirm that it is safe before changing lanes. Never rely solely on the Nissan Armada I-BSI system.
- The radar detection capability of the Nissan Armada has limitations. Not all vehicles or objects will be detected in every situation. Road conditions, weather, lane markings, and surrounding traffic may affect system performance. Always remain attentive and in control of the vehicle.
The Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system enhances driver awareness by detecting vehicles in adjacent lanes and, when necessary, actively assisting the driver by gently guiding the vehicle back toward the center of its lane.

Example
The Nissan Armada I-BSI system combines radar sensors (A), located near the rear bumper, with a forward-facing camera (B) mounted behind the windshield. This dual-sensor setup allows the system to monitor both surrounding vehicles and lane markings simultaneously for enhanced accuracy.

Detection zone
The detection area of the Nissan Armada extends from the side mirrors to approximately 10 ft (3.0 m) behind the vehicle and about 10 ft (3.0 m) outward on each side. This enables the system to effectively monitor blind spots and nearby traffic conditions.
Other materials
Tire Pressure Monitoring System Symptom
Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART Diagnosis items
Symptom
(Ignition switch ON) Low tire pressure warning lamp Cause Action
Low tire pressure warning lamp
The low tire pressure warning lamp illuminates for 1 second, then turns OFF.
Wake-up operation for all tire ...
Action Test
Work Procedure
Always perform the rear automatic braking system action test to check that the system operates normally after replacing the ADAS control unit 2 or repairing any rear automatic braking system malfunction.CHECK REAR AUTOMATIC BRAKING SYSTEM SETTING
Start the engine.
Check that the r ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal� described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...