Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECTED PART
Check each fixing bolt and nut for looseness using torque wrench. For each tightening torque, refer to followings;
Refer to Exploded View.
BACKLASH OF JOINT PART
Move the joint of propeller shaft up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the joint has no backlash extremely. If the joint has a malfunction, remove propeller shaft and perform inspection.

APPEARANCE AND NOISE
Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, adjust the propeller shaft phase first.
Check the propeller shaft for bend and damage. If damaged, replace propeller shaft assembly.
Perform a cruise test drive to check the propeller shaft for runout. If vibration occurs, separate propeller shaft at final drive companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft.
If vibration is still detected, measure propeller shaft runout after removing it. Refer to Inspection.
Other materials
Passenger compartment
Example
The interior of the Nissan Armada is designed for comfort, technology, and convenience.
This section outlines key controls, storage areas, and comfort features that enhance
the driving and passenger experience in the Nissan Armada.
Inside mirror
Overhead console
Map lights
...
Precautions
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal� described below.
NOTE:
Some ECUs operate for a certain fixed time ev ...
Usb Connector
Removal & Installation
REMOVALRemove the front center console cup holder assembly. Refer to Disassembly and Assembly.
Release the pawls and remove the USB connector from the front of the front center console cup holder assembly.
: Pawl
CAUTION:
Do not damage pawls.INSTALLATIONInstallatio ...