NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Calibration of Automatic Back Door Position Information

Nissan Armada 2025-2026 Service and Repair Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock / Calibration of Automatic Back Door Position Information

Description

When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.

  • After removing and installing, or replacing back door assembly

  • After removing and installing, or replacing spindle unit

Work Procedure

STEP 1

  1. Select “AUTOMATIC BACK DOOR” using CONSULT.

  2. Select “Reset auto back door status” of “WORK SUPPORT” mode.

  3. Touch “Initialize” to erase automatic back door position information.

>>

GO TO 2.

STEP 2

Fully close the back door manually.

>>

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic open operation.

>>

GO TO 4.

STEP 4

  1. The back door fully opens.

  2. Check that automatic back door warning buzzer sounds normally.

Does automatic back door warning buzzer sound normally?

YES>>

GO TO 5.

NO>>

GO TO 2.

STEP 5

Fully close the back door.

>>

WORK END

    Other materials

    Spark plugs
    Basic information WARNING Ensure the engine is off, the ignition is switched off, and the parking brake is securely engaged before servicing spark plugs in your Nissan Armada. CAUTION Always use the correct socket when removing spark plugs from your Nissan Armada to avoid damaging the compon ...

    Front Heater Core
    Removal and Installation REMOVALRemove front heater & cooling unit assembly. Refer to Removal and Installation. Disconnect front air mix door motor (passenger side) harness connector . Remove sub harness from front case lower assembly. Remove cooler packing. Remove fixing screws , and then r ...

    Headlining
    Removal and Installation CAUTION: Never damage the roof panel. Two workers are required for removal or installation in order to prevent damage. Never bend headlining assembly when removing or installing. REMOVALCAUTION: When removing, always use a remover tool that is made of plastic to prevent dam ...