Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Compressor Does Not Operate

Description

SYMPTOM

Compressor does not operate.

Diagnosis Procedure

NOTE:

  • Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.

  • Check that refrigerant is enclosed in cooler cycle normally. If refrigerant amount is shortage from proper amount, perform the inspection of refrigerant leakage.

CHECK MAGNET CLUTCH OPERATION

Check magnet clutch. Refer to Diagnosis Procedure.

Does it operate normally?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning parts.

CHECK REFRIGERANT PRESSURE SENSOR

Check refrigerant pressure sensor. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning parts.

CHECK A/C AUTO AMP. OUTPUT SIGNAL

With CONSULT

  1. Select “Data Monitor� mode of “HVAC� using CONSULT.

  2. Select “COMP REQ SIG� and “FAN REQ SIG�, and check status under the following conditions.

Monitor item Condition Status
COMP REQ SIG A/C switch OFF Off
ON On
FAN REQ SIG Front blower motor OFF Off
ON On

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Replace A/C auto amp. Refer to Removal and Installation.

    Other materials

    Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and suspected parts SYMPTOM Reference Noise Shake Vibration Shimmy Judder Poor quality ride or handling Improper installation, looseness × × × ...

    Roof Antenna
    Exploded View With ProPILOT ASSIST 2.1 Roof antenna             : N·m (kg-m, in-lb) Without ProPILOT ASSIST 2.1 Roof antenna             : N·m (kg-m, in-lb) Removal & Installation REMOVALRemove the headlining assemb ...

    Steering Torque Calibration
    Work Procedure After replacing the ADAS control unit 2 and after replacing or removing the following steering components, the steering torque calibration is necessary to operate the system normally. Steering wheel Spiral cable Steering angle sensor Steering column assembly Steering gear ass ...