Vehicle specification needs to be written with CONSULT because it is not written after replacing the sonar control unit.
The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the sonar control unit.
Refer to Work Procedure.
NOTE:
The configuration no need to “save” configuration data from the sonar control unit. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.
CAUTION:
Complete the procedure of “Replace ECU” in order.
If incorrect “Replace ECU”, incidents might occur.
Work Procedure
Work ProcedureWork Procedure
SYSTEM INITIALIZATION
NOTE:
System initialization is required for each seat.
System initialization can perform by power window main switch or power window switch on each seat.
Close the door.
Ignition switch ON.
Operate power window switch UP, and then release the switch after door glass to the ful ...
Adjustment
WARNING:
CAMBER
Adjust with adjusting bolt in front lower link.
Camber Refer to Wheel Alignment.
CAUTION:
When tightening the nut firmly and checking the torque, use a wrench to prevent the turning of bolt.
After adjusting camber, be sure to check toe-in.
After adjusting camber, be sure to perf ...
Removal and Installation
WARNING:
WITHOUT DYNAMIC DIGITAL SUSPENSION AND ELECTRONIC AIR SUSPENSION
Removal
Remove rear tire. Refer to ROAD WHEEL TIRE : Removal & Installation.
CAUTION:
Never depress brake pedal while caliper assembly is removed.
Remove disc rotor.
CAUTION:
Never drop disc rotor.
Remove wheel sensor h ...