SYSTEM INITIALIZATION
NOTE:
System initialization is required for each seat.
System initialization can perform by power window main switch or power window switch on each seat.
Close the door.
Ignition switch ON.
Operate power window switch UP, and then release the switch after door glass to the fully closed position.*1
Keep pulling the power window switch UP for 5 seconds or more and then release the switch. (Door glass may slightly move)
Keep pressing the power window switch DOWN, and then release the switch after door glass to the fully opened position.*2
Keep pressing the power window switch DOWN for 5 seconds or more and then release the switch. (Door glass may slightly move)
NOTE:
*1: If the door glass stops before reaching the fully closed position, release the switch and then continue pulling the power window switch UP again until the door glass fully closed.
*2: System initialization cancelled if the switch released while MANUAL DOWN operation. System initialization needs again from step 3.
>>GO TO 2.
CHECK THE FUNCTION
Check that AUTO UP function operates normally.
Check anti-pinch function. Refer to Description.
END
System Initialization
Anti-Pinch InspectionUltra High Strength Steel Part
DESCRIPTION
Ultra high strength steel parts signify high strength steel plates with tensile strength of 980 MPa or more.
When replacing parts made of ultra high strength steel or parts including ultra high strength steel, never perform the prohibition described below:
PROHIBITION
WARNING:
Never cut ...
Exploded View
WITHOUT ELECTRIC MOTOR
Steering column assembly Upper joint : N·m (kg-m, ft-lb)
WITH ELECTRIC MOTOR
Steering column assembly Upper joint : N·m (kg-m, ft-lb) ...
Exploded View
Drive pinion lock nut Companion flange Front oil seal Pinion front bearing Collapsible spacer Gasket Filler plug Drain plug Mounting insulator Gear carrier Mounting insulator Breather connector Side shaft bearing Snap ring Snap ring Side oil seal Side shaft Pinion rear bearing Pi ...