Nissan Armada 2025-2026 Service and Repair Manual: Diagnosis Procedure
CHECK TIRE PRESSURE
Ignition switch ON.
CAUTION:
Never start the engine.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Inspect or repair the tires or wheels.
CHECK LOW TIRE PRESSURE LOCATION INDICATOR
Check low tire pressure location indicator.
Does low tire pressure location indicator continues displaying?
YES>>GO TO 3.
NO >>INSPECTION END
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Perform self-diagnosis for "AIR PRESSURE MONITOR” of “BCM”.
Is DTC detected?
YES>>Perform DTC diagnosis procedure. Refer to DTC Index.
NO>>GO TO 4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Is the inspection result normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Repair or replace error-detected parts.
Low Tire Pressure Location Indicator Continues Displaying
The low tire pressure location indicator continues displaying though low tire pressure warning lamp turns/stays OFF. ...
Id Registration Cannot Be Completed
The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit. ...
Other materials:
SONAR SENSOR (FRONT) : Exploded View
CITY MODELS
Front bumper fascia Corner sensor front LH holder Corner sensor front LH Center sensor front LH holder Center sensor front LH Center sensor front RH holder Center sensor front RH Corner sensor front RH Corner sensor front RH holder Vehicle front
OFF ROAD MODELS (WITH WELDING ...
Comparision of Chemical and Physical Properties between Aluminum and Iron
Property Aluminum alloy Iron Effect of welding Melting temperature °C (°F) 560 - 640
(1,040 - 1,184) 600 × 2.5
(1,112 × 2.5) Aluminum alloy melts before it turns red.
This makes it difficult to judge the temperature.
Heat conduction efficiency
cal/cm/sec/°C (BTU in/m2/h/°F) 0.28
(812.69) ...
RADIATOR : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as per the following:
Be careful not to bend or damage radiator fins.
When radiator is cleaned without removal, remove all surrounding parts such as radiator cooling fan assembly and horns. Then tape harness and connectors to prevent w ...
0.005