CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>GO TO 2.
CHECK INSIDE KEY ANTENNA
Check inside key antenna.
NATS antenna amp.: Refer to DTC Diagnosis Procedure.
Console: Refer to DTC Diagnosis Procedure.
Luggage room: Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK OUTSIDE KEY ANTENNA
Check outside key antenna.
Rear door LH: Refer to DTC Diagnosis Procedure.
Rear door RH: Refer to DTC Diagnosis Procedure.
Rear bumper: Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
REGISTER INTELLIGENT KEY
Register the Intelligent Key again.
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 5.
REPLACE INTELLIGENT KEY
Replace the Intelligent Key and perform registration again.
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 6.
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Door Does Not Lock/unlock and Engine Does Not Start (req Sw/push Sw) (all Keys)
Door Does Not Lock/unlock and Engine Does Not Start (all I-Key/req Sw/push Sw)Work Procedure [After Replacing Chassis Control Module]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to chassis control module according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM NECESSARY WORK
With CONSULT
Perform configuration. Refer to Work Procedure.
Perform MAC key writing. Refer to ...
Anchoring with Frame Attachments
A difference between the frame anchoring and the uni-body anchoring is that the frame itself is held down. (For the basic anchoring methods for uni-bodies, refer to Securing the Vehicle.)
Frame straightening equipment makers offer the attachments for frame anchoring including those intended for any ...
Removal and Installation
WARNING:
REMOVAL
Shift the transmission to the neutral position, and then release the parking brake.
Put matching mark on rear propeller shaft flange yoke and transmission companion flange.
CAUTION:
For matching mark, use paint. Never damage propeller shaft flange and transmission companion flang ...