CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>GO TO 2.
CHECK POWER SUPPLY AND GROUND CIRCUIT
Check lntelligent Key unit power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK INTELLIGENT KEY-1
For both Intelligent Key that cannot be used for door lock and unlock, check that the Intelligent Key belongs to the vehicle to be checked.
Check if the Intelligent Key that is checked is the Intelligent Key for a different vehicle that the user owns.
Check that the Intelligent Key buttons match the vehicle specifications.
Does the Intelligent Key belong to the vehicle to be checked?
YES>>GO TO 4.
NO>>Check Intelligent Key button operation using a registered Intelligent Key that belongs to the vehicle.
CHECK INTELLIGENT KEY-2
Check the inside of the both Intelligent Key for rust or corrosion by water. Simultaneously check the internal circuits for damage.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Replace Intelligent Key.
REGISTER INTELLIGENT KEY
Register the Intelligent Key again.
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 6.
REPLACE INTELLIGENT KEY
Replace the Intelligent Key and perform registration again.
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 7.
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Check the operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Intelligent Key System All Functions Cannot Operate (all Keys)
Door Does Not Lock/unlock with Intelligent KeyWork Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor ...
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to combination meter following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.
NOTE:
Log in the network according to CONSULT guidance.
>>
WORK END ...
Exploded View
WITHOUT ELECTRIC MOTOR
Steering column assembly Upper joint : N·m (kg-m, ft-lb)
WITH ELECTRIC MOTOR
Steering column assembly Upper joint : N·m (kg-m, ft-lb) ...