WITHOUT ELECTRIC MOTOR

![]() | Steering column assembly | ![]() | Upper joint | ||
![]() | : N·m (kg-m, ft-lb) | ||||
WITH ELECTRIC MOTOR

![]() | Steering column assembly | ![]() | Upper joint | ||
![]() | : N·m (kg-m, ft-lb) | ||||
Steering Column
Removal and InstallationMeasurement with Manual Gauges
(1) MEASUREMENT WITH TRACKING GAUGES
Three types of deformations, side-sway, diamond and buckling, can be measured.
(a) Side-sway
This is checked by measuring the dimensions of the respective crossmember diagonal lines and comparing them to see if any differences are present.
(b) Diamond
Measure ...
Removal and Installation
REMOVAL
Remove headlining assembly. Refer to Removal and Installation.
Disconnect IR sensor harness connector .
Remove room lamp harness from IR sensor assembly.
Disengage fixing pawls, and then remove IR sensor finisher and IR sensor assembly .
: Pawl
INSTALLATION
Install in the reverse o ...
Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment.
Observe the following precautions when disassembling.
Before disassembly, thoroughly clean the outside of the unit.
Disassembly should be done in a clea ...