CHECK AUTO OPEN/CLOSE FUNCTION
Check auto open/close function using automatic back door switch.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Refer to Diagnosis Procedure.
CHECK INTELLIGENT KEY
For automatic back door lock and close switch cannot be used for auto close function, check the Intelligent Key is near the rear bumper.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Confirm the operation.
CHECK AUTOMATIC BACK DOOR LOCK AND CLOSE SWITCH
Check automatic back door lock and close switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
REPLACE AUTOMATIC BACK DOOR CONTROL UNIT
Replace automatic back door control unit. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Automatic Back Door Lock and Close Switch
Automatic Back Door Close SwitchDraining
WARNING:
IN CASE REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
Regarding brake fluid draining, refer to Work Procedure.
IN CASE NOT REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
CAUTION:
Connect a vinyl tube to the bleed valve.
Depress the brake pedal and ...
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK LOW BEAM REQUEST SIGNAL
With CONSULT
Select “Low beam request” in “Data Monitor” mode of “ ...
Removal and Installation
REMOVAL
Apply protective tape (A) on the part to protect it from damage.
Disengage radiator core seal fixing clips using a remover tool (A), and then remove radiator core seal .
: Clip
INSTALLATION
Install in the reverse order of removal. ...