PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure. Refer to Description.
>>INSPECTION END
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Removal and Installation
WARNING:
REMOVAL
Shift the transmission to the neutral position, and then release the parking brake.
Put matching mark on rear propeller shaft flange yoke and transmission companion flange.
CAUTION:
For matching mark, use paint. Never damage propeller shaft flange and transmission companion flang ...
Work Procedure
START
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
ELECTRIC INTAKE VALVE TIMING (IVT) CONTROL ACTUATOR REFERENCE POSITION LEARNING
With CONSULT
Ignition switch ON.
On CONSULT screen, select All DTC Reading and check that any DTC is not detected.
Select “ECM” >> “Work s ...