Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

START

Do you have CONSULT?

YES>>

GO TO 2.

NO>>

GO TO 3.

ELECTRIC INTAKE VALVE TIMING (IVT) CONTROL ACTUATOR REFERENCE POSITION LEARNING

With CONSULT

  1. Ignition switch ON.

  2. On CONSULT screen, select All DTC Reading and check that any DTC is not detected.

  3. Select “ECM” >> “Work support” >> “Electric intake valve timing control learning”.

  4. Touch “Start” and start the engine within 10 seconds.

  5. Let the engine be idle.

  6. Check that “COMPLETED” is displayed.

Is the learning completed normally?

YES>>

END

NO>>

Check that DTC is not detected and restart the learning.

PERFORM ELECTRIC IVT CONTROL ACTUATOR REFERENCE POSITION LEARNING

Without CONSULT

  1. Ignition switch OFF.

  2. Disconnect electric IVT control actuator harness connector (actuator side).

  3. Ignition switch ON and wait at least 70 seconds.

  4. Ignition switch OFF.

  5. Reconnect the disconnected harness connector.

  6. Start engine and let it idle at least 15 seconds.

  7. Ignition switch OFF.

  8. Check and erase DTC.

>>

END

Electric Ivt Control Actuator Position Learning
Electric intake valve timing control (IVT) module requires the learning of camshaft reference position. This learning must be performed where the following operations are performed: Replacement of el ...

Throttle Valve Closed Position Learning
Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed eac ...

Other materials:

Removal and Installation
REMOVAL Remove rear fillet molding rear fixing clips and screws . Apply protective tape (A) on the part to protect it from damage. Insert a remover tool (A) between rear fillet molding rear and rear fender panel, and then cut double-sided tape using a cutter (B) while lifting rear fillet moldin ...

Removal and Installation
CAUTION: Never bend the fixing pawl of rear armrest. REMOVAL Remove rear door finisher. Refer to Removal and Installation. Disconnect rear power window switch harness connector. Remove rear armrest fixing screws , and then remove rear armrest from rear door finisher . : Pawl Remove rear power ...

Sonar system limitations
WARNING The following limitations apply to the Nissan Armada sonar system. Failure to understand and follow these limitations may result in serious injury or even fatal accidents. Carefully review all limitations of the Nissan Armada sonar system. Environmental conditions such as heavy r ...

© 2014-2026 Copyright www.niarmada.com
 
0.0094