The ProPILOT Assist switch can be turned ON/OFF; however,ProPILOT Assist 1.1 cannot be set by pressing the SET- switch.
NOTE:
The system cannot be set in the following cases.
When traveling below 30 km/h (19 MPH) and a vehicle ahead is not detected
When the shift position is moved out of the D (Drive) position or into the manual shift mode
When the parking brake is applied
When the brakes are operated by the driver
When the VDC system is OFF
When the VDC system (including the traction control system) is activated
When the SNOW mode or OFF-ROAD mode is selected (AWD models)
When a wheel is slipping
When any door is open
When the driver’s seat belt is not fastened
CHECK EACH SWITCH AND VEHICLE SPEED SIGNAL
Start the engine.
Check that the following items operate normally in “DATA MONITOR” of “ICC/ADAS 2”.
“Vehicle speed”
"SET/COAST SW"
"BRAKE SW"
Is there a malfunctioning item?
“Vehicle speed”>>Refer to DTC Description.
"SET/ COAST SW">>Refer to DTC Diagnosis Procedure.
“BRAKE SW”>>Refer to DTC Description.
Symptom Table
NOTE:
Symptom Possible cause Inspection item Front wiper (HI, LO) does not operate normally BCM
Combination switch
Harness between combination switch and BCM
Combination switch
Refer to Symptom Table. Harness between BCM and front wiper motor
Harness between fuse block (J/B) and front wiper re ...
Removal and Installation
REMOVAL
Remove emblem from the panel while warming using an industrial dryer.
CAUTION:
Never damage the painted surface of the panel when removing.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Never reuse the emblem which was peeled.
Degrease the ...
Exploded View
Heat shield A/T assembly Joint tube Control valve & TCM Oil pan Joint tube Joint tube Tube Refer to Removal and Installation. Refer to Removal and Installation. : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Always replace after every disassembly. : Apply ATF : Apply petroleum jelly ...