Description
INTERVIEW SHEET SAMPLE
| Interview sheet | |||||
|---|---|---|---|---|---|
| Customer name | MR/MS | Registration number | Initial year registration | ||
| Vehicle type | VIN | ||||
| Storage date | Traction motor | Mileage | km ( Mile) | ||
| Symptom | â–¡ Does not operate ( | ) function | |||
| â–¡ Warning lamp for ( | ) turns ON. | ||||
| □ Noise                 □ Vibration | |||||
| â–¡ Other( | ) | ||||
| First occurrence | â–¡ Recently â–¡ Other ( | ) | |||
| Frequency of occurrence | â–¡ Always â–¡ Under a certain conditions of â–¡ Sometimes ( time(s)/day) | ||||
| Climate conditions | â–¡ Irrelevant | ||||
| Weather | â–¡ Fine â–¡ Cloud â–¡ Rain â–¡Snow â–¡ Others ( | ) | |||
| Temperature | □ Hot □Warm □ Cool □ Cold □ Temperature [Approx. | °C ( °F)] | |||
| Relative humidity | â–¡ High â–¡ Moderate â–¡ Low | ||||
| Road conditions | â–¡ Urban area â–¡ Suburb area â–¡ Highway â–¡ Mountainous road (uphill or downhill) â–¡ Rough road | ||||
| Operating condition, etc. | â–¡Irrelevant â–¡When traction motor starts â–¡ During idling â–¡ During driving â–¡ During acceleration â–¡ At constant speed driving â–¡ During deceleration â–¡ During cornering (right curve or left curve) â–¡ When steering wheel is steered (to right or to left) | ||||
| Other conditions | |||||
| Memo | |||||
Work FlowAdditional Service When Replacing Around View Monitor Control Unit
CAUTION:
When replacing the around view monitor control unit, always replace it with a new one. Around view monitor system does not operate properly in case of reuse of the around view monitor control unit from another vehicle.
When before writing the around view monitor control unit configuration, ...
Diagnosis Procedure
CHECK FAIL-SAFE ACTIVATION
Check if the symptom is caused by a fail-safe operation. Refer to Fail-Safe.
Is fail-safe operating?
YES>>
Repair the part causing fail-safe operation.
NO>>
GO TO 2.
CHECK INVERTER UNIT POWER SUPPLY CIRCUIT
Check inverter unit power supply circuit. Refer to D ...
Removal and Installation
REMOVAL
Remove luggage side lower finisher RH. Refer to Removal and Installation.
Disconnect rear mode door motor harness connector .
: Vehicle front
Remove fixing screws , and then remove rear mode door motor.
INSTALLATION
Install in the reverse order of removal. ...