Exploded View
 |
Rear final drive assembly |  |
Differential lock position switch | ||
 |
O-ring | ||||
 : N·m (kg-m, in-lb) |
|||||
 : Apply gear oil. |
|||||
Removal and Installation
REMOVAL
Ignition switch OFF.
Disconnect negative battery terminal.
Disconnect the differential lock position switch harness connector.
Remove differential lock position switch mounting bolt (
) and remove differential lock position switch 
.
-
Rotate differential lock position switch counterclockwise then pull out to remove as shown.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Apply gear oil to the O-ring.
-
Never damage the O-ring of differential lock position switch.
-
Never contaminate or damage the O-ring mounting surface.
Other materials
Engine Cover
Exploded View
Engine cover
Stud bolt
Engine cover bracket 1
Engine cover bracket 2
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVALRemove engine cover.
If necessary r ...
Rear Door Parting Seal
Removal and Installation
REMOVALRear Door Parting Seal FrontFully open rear door.
Remove rear door parting seal front clip.Apply protective tape (A) to rear door panel around rear door parting seal front clip for preventing damage.
Disengage fixing pawls using a remover tool (A), and then remove re ...
Engine Coolant
Service Data
ENGINE COOLANT CAPACITY (APPROXIMATELY)Unit: ℓ (US qt, Imp qt) Engine coolant capacity [With reservoir tank (“MAX” level)]
13.0 (13-6/8,11-4/8)
Reservoir tank engine coolant capacity (At “MAX” level)
1.61 (1-6/8,1-3/8)
...