Nissan Armada 2025-2026 Service and Repair Manual: Disassembly and Assembly
DISASSEMBLY
Remove drain plug and gasket from rear cover and drain gear oil.
Remove filler plug and gasket from rear cover.
Remove the side oil seals. Refer to Removal and Installation.
Remove rear cover mounting bolts (
) and remove the rear cover 
.
Remove stud bolt from rear cover.
NOTE:
It is not necessary to remove stud bolt except when it is replaced.
ASSEMBLY
Install stud bolt to rear cover.
For tightening torque, refer to Exploded View.
Apply liquid gasket to mating surface of rear cover.
For applying liquid gasket, refer to Exploded View.
CAUTION:
Install rear cover, and tighten rear cover mounting bolts to the specified torque.
For tightening torque, refer to Exploded View.
CAUTION:
Install the mounting bolts of rear cover according to the following standards.
| Bolt symbol |  |  |
|---|---|---|
| Number of bolt | 5 | 5 |
| Bolt size | M12 | M10 |
Install the side oil seals. Refer to Removal and Installation.
Install drain plug, as per the following procedure.Install gasket to drain plug, and then install them to rear cover.
CAUTION:
Never reuse gasket.
Tighten drain plug to the specified torque.For tightening torque, refer to Exploded View.
Install filler plug, as per the following procedure.Install gasket to filler plug, and then install them to rear cover.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque.For tightening torque, refer to Exploded View.
CAUTION:
Fill with gear oil before tightening filler plug to the specified torque.
Exploded View
Side oil seal Rear final drive assembly Rear cover Gasket Drain plug Stud bolt Filler plug : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Apply Genuine Liquid Gasket, Three B ...
Other materials:
Head Up Display
WARNING:
Never adjust properly the brightness and position of the displayed Head Up Display (HUD) image may interfere with the drivers ability to see through the windshield glass which could cause an accident leading to severe injury or death.
Never use the HUD for extended periods of time as that c ...
Removal and Installation
WARNING:
REMOVAL
CAUTION:
Front Washer Tube A
Remove washer tank assembly. Refer to Removal and Installation.
Remove front fender drip cover RH. Refer to Removal and Installation.
Disconnect front washer tube A form connector.
Remove front washer tube A fixing clip, and then remove front washer tube ...
Work Procedure
CHOOSE METHOD
There are two ways of learning method.
Which method do you choose?
With CONSULT>>
GO TO 2.
Without CONSULT>>
GO TO 3.
WITH CONSULT
With CONSULT
Ignition switch ON.
Perform "Steering column position learning” in "Work support" mode of "STEERING COLUMN” using CONSULT.
...
0.007