Nissan Armada 2025-2026 Service and Repair Manual: Disassembly and Assembly
DISASSEMBLY
Remove seatback trim and pad. Refer to Disassembly and Assembly.
Disengage seat cushion trim fixing retainers 
.
Disengage seat cushion trim fixing retainers .
Disengage harness fixing clip of seat cushion, and then disconnect harness connector.
CAUTION:
Remove seat cushion trim and pad as a set from seat frame assembly.
Remove hog rings, and then separate seat cushion trim and pad.
CAUTION:
Never disassemble seat cushion pad and seat cushion heater (if equipped).
ASSEMBLY
CAUTION:
Always install hog ring in position.
Never reuse hog ring after disassembly, using new hog ring.
Use new hog ring if removed or crimped unsuccessfully.
Be installed harnesses and harness fixing clips in position.
Other materials:
Refilling
WARNING:
The ignition switch OFF.
Recommended fluid and capacity: Refer to Fluids and Lubricants.
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specif ...
Removal and Installation
REMOVAL
CAUTION:
Never reuse combination switch. Always replace it with a new one when it is removed.
Remove spiral cable. Refer to Removal & Installation.
Disconnect harness connector from combination switch.
Remove the combination switch mounting screw .
Pull out the combination switch by ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
0.0055