INSPECTION AFTER INSTALLATION
Check clearance between tail tube and rear bumper is even.
With engine running, check exhaust tube joints for gas leakage and unusual noises.
Check to ensure that mounting brackets and mounting rubbers are installed properly and free from undue stress. Improper installation could result in excessive noise and vibration.
EXHAUST SYSTEM : Removal & InstallationRemoval and Installation
WARNING:
REMOVAL
WARNING:
CAUTION:
Never depress the brake pedal while removing the brake pads because the piston may pop out.
If the brake fluid or grease adheres to the brake caliper assembly and disc rotor, quickly wipe it off.
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation. ...
Draining
WARNING:
IN CASE REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
Regarding brake fluid draining, refer to Work Procedure.
IN CASE NOT REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
CAUTION:
The ignition switch OFF and disconnect the ABS actuator and electric un ...
EXHAUST SYSTEM : Removal & Installation
WARNING:
REMOVAL
Remove spare tire. Refer to Removal & Installation.
Remove rear muffler with the following procedure: Loosen the mounting nut of the mounting bracket .
CAUTION:
Be careful not to hit the rear muffler with the tool.
Remove mounting rubber 1 and rear muffler from the vehicle ...