Bank 1 side
![]() | Ignition coil | ![]() | Spark plug | ![]() | Rocker cover |
![]() | Rocker cover gasket | ![]() | Blow-by hose 1 (bank 1) | ![]() | Clamp |
![]() | Blow-by hose 2 (bank 1) | ![]() | Intake camshaft position sensor | ![]() | Exhaust camshaft position sensor |
![]() | Crankcase pressure sensor | ||||
![]() | Comply with the installation procedure when tightening. Refer to Removal and Installation. | ![]() | Camshaft bracket side | ![]() | To rocker cover (bank 2). |
![]() | To intake manifold. Refer to Exploded View. | ||||
![]() | : N·m (kg-m, ft-lb) | ||||
![]() | : N·m (kg-m, in-lb) | ||||
![]() | : Always replace after every disassembly. | ||||
![]() | : Should be lubricated with oil. | ||||
![]() | : Sealing point | ||||
![]() | : Indicates that the parts is connected at points with same symbols in actual vehicle. | ||||
Bank 2 side
![]() | Oil filler cap | ![]() | Oil filler tube | ![]() | O-ring |
![]() | Rocker cover gasket | ![]() | Rocker cover | ![]() | Spark plug |
![]() | Ignition coil | ![]() | Intake camshaft position sensor | ![]() | Exhaust camshaft position sensor |
![]() | Clamp | ![]() | Blow-by hose (bank 2) | ||
![]() | Comply with the installation procedure when tightening. Refer to Removal and Installation. | ![]() | Camshaft bracket side | ![]() | To air duct. Refer to Exploded View. |
![]() | To rocker cover (bank 1). | ||||
![]() | : N·m (kg-m, ft-lb) | ||||
![]() | : N·m (kg-m, in-lb) | ||||
![]() | : Always replace after every disassembly. | ||||
![]() | : Should be lubricated with oil. | ||||
![]() | : Sealing point | ||||
![]() | : Indicates that the parts is connected at points with same symbols in actual vehicle. | ||||
Removal and InstallationPrecautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
PRECAUTIONS FOR REMOVING BATTERY TERMINAL
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Infants
Infants traveling in the Nissan Armada should always be placed in a rear-facing
child restraint system for maximum safety. It is strongly recommended that children
remain in this position until at least 1 year of age, or longer if possible, depending
on the limits of the child restraint.
NISS ...