
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"Work Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor ...
Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the air suspension contorol module.
For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure
WRITING VEHICLE SPECIFICATION AND VIN
With CONSULT
Perform writing vehic ...
NVH Troubleshooting Chart
Possible cause and SUSPECTED PARTS Symptom Reference Vibration Shake Noise Uneven rotating torque × × Inspection Center bearing improper installation × × × Exploded View Excessive center bearing axial end play × × Inspection Center bearing mounting (insulator) cracks, dama ...