Nissan Armada 2025-2026 Service and Repair Manual: Exploded View
 | Drive pinion lock nut |  | Companion flange |  | Front oil seal |
 | Pinion front bearing |  | Collapsible spacer |  | Gasket |
 | Filler plug |  | Drain plug |  | Mounting insulator |
 | Gear carrier |  | Mounting insulator |  | Breather connector |
 | Side shaft bearing |  | Snap ring |  | Snap ring |
 | Side oil seal |  | Side shaft |  | Pinion rear bearing |
 | Pinion height adjusting washer |  | Drive pinion |  | Drive gear |
 | Differential assembly |  | Carrier cover |  | Bearing cap |
 | Side bearing |  | Side bearing adjusting washer |  | Spacer |
 | Side oil seal | ||||
 | Screw hole |  | Comply with the assembly procedure when tightening. Refer to Disassembly and Assembly. | ||
 : N·m (kg-m, ft-lb) | |||||
 : Always replace after every disassembly. | |||||
 : Select with proper thickness. | |||||
 : Apply Genuine Liquid Gasket, Three Bond 1217 or equivalent. Refer to Recommended Chemical Products and Sealants. | |||||
 : Apply Genuine High Strength Thread Locking Sealant, Loctite 270 or equivalent. Refer to Recommended Chemical Products and Sealants. | |||||
Drive Pinion
...
Disassembly and Assembly
DISASSEMBLY
Remove side shaft assembly. Refer to Disassembly and Assembly.
Remove differential assembly. Refer to Disassembly and Assembly.
While holding companion flange with the flange wrench (A) (c ...
Other materials:
Work Procedure
After replacing the ADAS control unit 2 and after replacing or removing the following steering components, the steering torque calibration is necessary to operate the system normally.
Steering wheel
Spiral cable
Steering angle sensor
Steering column assembly
Steering gear assembly
NOTE:
Follow the ...
Removal and Installation
REMOVAL
Disconnect the battery cable from the negative terminal.
Disengage the fixing pawl on the vehicle front side of the IPDM E/R cover A and then pull up IPDM E/R cover A.
: Pawl
Disengage the fixing pawls on the vehicle rear side of the IPDM E/R cover A and then remove IPDM E/R cover A.
...
Removal and Installation
REMOVAL
Remove front seatback trim and pad. Refer to Disassembly and Assembly.
Disengage fixing pawls and then remove front seatback blower motor.
: Pawl
Disengage front seatback blower motor harness fixing clip.
Disconnect front seatback blower motor connector and then remove front seatback blow ...
0.0051