Removal and Installation
REMOVAL
Front Air Mix Door Motor (Driver Side)
Remove instrument lower panel LH and steering column cover lower. Refer to Removal and Installation.
Remove driver knee air bag module. Refer to Removal and Installation.
Remove side ventilator duct 2 LH. Refer to Removal and Installation.
Disconnect front air mix door motor (driver side) harness connector 
.
| : vehicle front |
Remove fixing screws , and then remove front air mix door motor (driver side).
Front Air Mix Door Motor (Passenger Side)
Remove front heater & cooling unit assembly. Refer to Removal and Installation.
Remove front heater core. Refer to Removal and Installation.
Remove fixing screws , and then remove front air mix door motor (passenger side).
INSTALLATION
Install in the reverse order of removal.
Other materials
On Board Diagnostic (obd) System
ON BOARD DIAGNOSTIC (OBD) SYSTEM : Precautions
The ECM has an on board diagnostic system. It will illuminate the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.CAUTION:
Always turn the ignition switch OFF and disconnect the negative battery cabl ...
Transfer Fluid
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
FLUID LEAKAGECheck t ...
Repairing Material
Foam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...