Removal and Installation
REMOVAL
Remove TORX bolts, and then remove front door striker.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Never reuse TORX bolt. Always replace it with a new one when it is removed.
-
Before tighten front door striker mounting TORX bolts to the specified torque, perform the fitting adjustment. Refer to Adjustment.
Other materials
Reservoir Tank Cap
Inspection
Check valve seat of reservoir tank cap.
: Metal plunger
Check if valve seat is swollen to the extent that the edge of the metal plunger cannot be seen when watching it vertically from the top.
Check if valve seat has no soil and damage.
Pull negative-pressure valve to ...
Vr35ddtt
Exploded View
Transmission housing
Starter motor cover 1
Starter motor cover 2
“B” terminal harness
Starter motor harness connector
Starter motor
: vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Indicates that the part is connected at points with same s ...
The Fuel Gauge Indicator Does Not Operate
Diagnosis Procedure
Fuel gauge will not indicate from a certain position.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to On Board Diagnosis Function.
Is the inspection result no ...