Removal and Installation
CAUTION:
Never damage the body panel.
REMOVAL
Apply protective tapes (A) on assist grip to protect it from damage.
Disengage assist grip cap fixing pawls of assist grip using a remover tool (A), and then remove assist grip cap of assist grip.
 |
: Pawl |
Remove assist grip mounting bolts, and then remove assist grip.
Disengage front pillar garnish fixing clip and metal clip according to numerical order 1→2 indicated by arrows as shown in the figure.
 |
: Clip |
 |
: Metal clip |
Disengage front pillar garnish fixing portions, and then remove front pillar garnish.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Visually check clip and metal clip for deformation and damage during installation. Replace with new ones if necessary.
-
Check in advance that clip and metal clip are accurately aligned with the portions on body panel, and then install by pressing in.
-
After installation, check that the lip of body side welt covers. Refer to Inspection.
Other materials
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Rear Power Window Switch
Removal and Installation
CAUTION:
Never bend the fixing pawl of rear armrest.REMOVALRemove rear door finisher. Refer to Removal and Installation.
Disconnect rear power window switch harness connector.
Remove rear armrest fixing screws , and then remove rear armrest from rear door finisher .
: Pa ...
Writing of Calibration Data
Work Procedure
DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA
With CONSULT
...