Work Procedure
DESCRIPTION
If only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.
WORK PROCEDURE
WRITE CALIBRATION DATA
With CONSULT
-
Select "CALIBRATING CAMERA IMAGE" of "Work Support" mode using CONSULT.
-
After displaying the status, check that the status is displayed as "Normal".
Is the status of each camera displayed as "Normal"?
YES>>INSPECTION END
NO>>Calibrate the camera that is not displayed as "normal". Refer to Work Procedure.
Other materials
Basic information
The front and rear sonar system in the Nissan Armada is designed to assist the
driver during parking and low-speed maneuvers by detecting obstacles around the
vehicle. Using ultrasonic sensors integrated into the front and rear bumpers, the
Nissan Armada provides audible tones and visual i ...
Front
Exploded View
Side defroster nozzle RH
Center defroster nozzle
Side defroster nozzle LH
Instrument panel assembly
Side ventilator grille LH
Instrument finisher A
Ionizer
(with ionizer models)
Side ventilator duct 1 LH
Side ventilator duct 3 LH
Side ventilator duct 2 L ...
Automatic Back Door Switch Finisher
Removal and Installation
CAUTION:
Never damage the back door panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Fully open back door.
Apply protective tape (A) on back door lower finisher to protect it from damage.
Disengage automa ...