Disassembly and Assembly
DISASSEMBLY
Remove inside and outside seat cushion finisher outer. Refer to Disassembly and Assembly.
Disengage seatback board fixing retainer 
.
-
With 4way power seat system
-
With 8way power seat system
Disengage seat cushion trim fixing retainers .
-
With 4way power seat system
-
With 8way power seat system
Disengage seat cushion trim fixing retainers .
Disengage harness fixing clip of seat cushion, and then disconnect harness connector.
CAUTION:
Before performing removal operation, check the installation position of harness connector and harness fixing clip.
Remove seat cushion trim and pad as a set from seat frame assembly.
Remove hog rings, and then separate seat cushion trim and pad.
CAUTION:
-
Before removing hog rings, check its position because it should be installation in position.
-
Never disassemble seat cushion pad and seat cushion heater (if equipped).
-
Never disassemble seat cushion pad
and seat cushion bellows (if equipped).
Remove the following parts after removing seat cushion trim and pad from seat frame assembly.
-
Seat cushion blower motor (if equipped). Refer to Removal and Installation.
-
Seat cushion suspension.
-
Seat cushion trim bracket.
Remove occupant detection system control unit (passenger seat).Disconnect harness connector from occupant detection system control unit. Remove fixing screws, and then remove occupant detection system control unit.
Remove driver seat control unit (if equipped). Refer to Removal and Installation.
Remove passenger seat control unit (if equipped). Refer to Removal and Installation.
Remove seat cushion harness bracket.Disengage harness fixing clips from seat cushion harness bracket.
CAUTION:
Before performing removal operation, check the installation position of harness connectors and harness fixing clips.
Remove fixing screws, and then remove seat cushion harness bracket.ASSEMBLY
Note the following items, and then assemble in the reverse order of disassembly.
CAUTION:
-
If occupant detection system control unit of passenger seat is replaced, perform the zero point reset operations. Refer to Description.
-
If seat frame assembly is replaced, perform the zero point reset. Refer to Description.
-
Always install hog ring in position.
-
Never reuse hog ring after disassembly, using new hog ring.
-
Use new hog ring if removed or crimped unsuccessfully.
-
Be installed harnesses and harness fixing clips in position.
-
If harnesses clip be broken, replace with new clip and it install in position where marked before removing clip.
Other materials
Basic information
WARNING
Failure to properly follow the safety guidelines and operating instructions
for the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system may result
in serious injury or even fatal accidents.
The Nissan Armada I-BSI system is designed as a driver assistance feature
and ...
Does Not Operate
Description
VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function does not operate.
Diagnosis Procedure
CAUTION: ...
Front Floor Carpet
Removal and Installation
CAUTION:
Never damage the body panel.REMOVALRemove seat.Remove front seat assembly (LH and RH). Refer to Removal and Installation. Remove second seat assembly (LH and RH).
Captain seat: Refer to Removal and Installation.
Bench seat: Refer to Removal and Installation.
...