Nissan Armada 2025-2026 Service and Repair Manual: I-FCW System Service
CAUTION:
Do not use distance sensor removed from vehicle. Never disassemble or remodel.
When replacing the distance sensor, perform radar alignment.
Precautions For Harness Repair
CAN communication uses a twisted pair line. Be careful when repairing it.
Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 ...
LDW System Service
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Never perform the active test while driving.
Never disassemble and remodel the front camera ...
Other materials:
Inner Rear Pillar
WARNING:
Work after rear fender, inner rear pillar reinforcement, and back pillar reinforcement are removed.
Remove the welding point for easier installation.
Urethane foam : Vehicle front
: Weld the parts onto the back of the component part. Replacement part • Inner rear pillar • Inner ...
Welding of Ultra High Strength Steel
SPOT WELDING
Spot welding is limited to ultra high strength steel (tensile strength: 980 MPa) according to the welding conditions listed below.
CAUTION:
If the below welding conditions cannot be met, then perform plug welding.
Never spot weld ultra high strength steel of tensile strength more than 9 ...
Frame Component Parts
2WD MODELS
Refer to parts catalogue for the replacement parts.
: Both sided anti-corrosive precoated steel sections
: High strength steel (HSS) sections
: Aluminum portion
No. Parts name Tensile
strength
(MPa) Both sided
anti-corrosive
precoated
steel sections Aluminum
portion Frame assembly ...
0.0082