WARNING:
Work after lower side dash assembly, center pillar, outer sill, and inner center pillar are removed.

| Unit: mm (in) | |||||
: Vehicle front | |||||
: Drill φ7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel). | |||||
: Drill φ8 mm (0.31 in) hole for the plug welding hole (ultra high strength steel). | |||||
: Drill φ10 mm (0.39 in) hole for the plug welding hole (ultra high strength steel). | |||||
| Replacement part | |||||
| • | Inner sill | ||||

: Vehicle front | |||||
: Drill φ7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel). | |||||
: Drill φ8 mm (0.31 in) hole for the plug welding hole (ultra high strength steel). | |||||
: Weld the parts onto the back of the component part. |
Inner Center Pillar
Front FloorNormal Operating Condition
Symptom Possible cause Unstable object detection The vehicle is on a rough surface, such as stone or gravel.
When used in poor weather conditions, such as heavy snow/rain or strong wind.
When subjected to an ultrasonic noise generated from exhaust muffler or brakes.
When left standing in the hot ...
When SRS is not activated in a collision
CAUTION:
WORK PROCEDURE
Check the SRS components using the table below.
Ensure entire SRS operates properly.
SRS INSPECTION (FOR REAR COLLISION)
Part Inspection Driver air bag module If the driver air bag has not been activated:
Remove driver air bag module. Check harness cover and connectors fo ...
Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
CAUTION:
>>
GO TO 2.
CHECK SYMPTOM
CAUTION:
>>
GO TO 3.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
Ignition switch OFF (Auto ACC function OFF) to ON.
Perform self-diagnosis for “ABS”.
Is DTC detected?
YES>>
Record or print self-di ...