Nissan Armada 2025-2026 Service and Repair Manual: Inspection
WARNING:
INSPECTION BEFORE REMOVAL
Drive belt
WARNING:
Be sure to perform the this step when engine is stopped.
Check that the indicator (notch on fixed side) of drive belt auto-tensioner is within the possible use range.
NOTE:Check the drive belt auto-tensioner indication when the engine is cold.
Visually check the entire drive belt for wear, damage or crack.
If the indicator (notch on fixed side) is out of the possible use range or belt is damaged, replace drive belt.
A/C compressor belt
WARNING:
Perform this step when engine is stopped.(30 min or longer after engine is stopped)
Visually check entire drive belt for wear, damage or cracks.
Using a tensiometer and confirm belt tension or vibration frequency value.
NOTE:Before measuring, turn crankshaft pulley twice.
Measure belt
tension at "
" points. (Both side measurement are correct)
Confirm the belt tension value or the vibration frequency value. (see table below)
Belt tension Frequency 580 - 1327 N 192 - 292 Hz
INSPECTION AFTER INSTALLATION
Drive belt
Turn crankshaft pulley clockwise several times to equalize tension between each pulley, and then confirm tension of drive belt at indicator (notch on fixed side) is within the possible use range. Refer to Exploded View.
Adjustment
Refer to Drive Belt. ...
Spark Plug
...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Removal and Installation
REMOVAL
CAUTION:
Drain engine coolant from cooling system. Refer to ENGINE COOLANT : Draining.
Disconnect rear cooler pipe assembly from rear A/C unit assembly. Refer to Removal and Installation.
Remove luggage side lower finisher RH. Refer to Removal and Installation.
Remove each duct.
Rear inlet ...
LiquidGasket
LIQUID GASKET APPLICATION PROCEDURE
Remove old liquid gasket adhering to the liquid gasket application surface and the mating surface.
Remove liquid gasket completely from the liquid gasket application surface, mounting bolts, and bolt holes.
Wipe the liquid gasket application surface and the matin ...
0.0054