INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
Removal and InstallationTIRE AIR PRESSURE : Service Data
Unit: kPa (kg/cm2, psi)
Tire size Air pressure Front Rear 265/70R18 116H 240 (2.4, 35) 240 (2.4, 35) 275/60R20 115H 230 (2.3, 33) 230 (2.3, 33) 275/60R20 115H [A/T (ALL TERRAIN)] 240 (2.4, 35) 240 (2.4, 35) 275/50R22 111H 240 (2.4, 35) 240 (2.4, 35) 265/70R18 116H (Emergency) 350 ( ...
On Board Diagnostic (OBD) System of Engine and A/T
The ECM and TCM have an on board diagnostic system. It will illuminate the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.
CAUTION:
Always turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection work. ...
Inspection
INSPECTION AFTER REMOVAL
Camshaft Runout
Put V-block on precise flat table, and support No. 2 and 4 journals of camshaft.
CAUTION:
Never support No. 1 journal (on the side of camshaft sprocket) because it has a different diameter from the other three locations.
A : Dial indicator
Set a dial in ...