Nissan Armada 2025-2026 Service and Repair Manual: Inspection
INSPECTION AFTER REMOVAL
Appearance
Propeller Shaft Runout
| Propeller shaft runout | : Refer to Propeller Shaft Tube. |
Journal Axial Play
| Journal axial play | : Refer to Journal. |
Joint Flex Torque
| Joint flex torque | : Refer to Journal. |
INSPECTION AFTER INSTALLATION
Disassembly and Assembly
DISASSEMBLY
Put a matching mark between propeller shaft and flange yoke as shown.
CAUTION:
For matching mark, use paint. Never damage the surface.
Remove snap rings .
Lightly tap bottom of yoke us ...
Other materials:
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Ignition switch ON.
Perform writing vehicle specification to BCM following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.
NOTE:
Log in the network according to CONSULT guidance.
>>
WORK END ...
Shrinking
(1) FLAME SHRINKING
The area should be heated to approximately 250°C.
Aluminum alloy panels do not turn red when heated like steel plates. Prior to heating up the panel you are trying to repair, first practice with a scrap piece to get a good idea of how much heat is needed. This way the number of ...
Component Inspection (Heated Steering Wheel Relay)
CHECK HEATED STEERING WHEEL RELAY CONTINUITY
Check continuity between heated steering wheel relay terminals.
CAUTION:
Connect the fuse between the terminals when applying the voltage.
Heated steering wheel relay Condition Continuity Terminal 3 − 5 Apply 12 V direct current between terminals ...
0.0063