WARNING:
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Remove engine under cover. Refer to Exploded View.
Check oil level from filler plug mounting hole as shown in the figure after removing filler plug
and gasket from final drive assembly.

CAUTION:
The ignition switch OFF while checking oil level.
Oil level should be level with bottom of filler plug mounting hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Install engine under cover. Refer to Exploded View.
DrainingRemoval and Installation
REMOVAL
Using a suitable tool, release clips , and remove cover .
Disconnect inside camera (driving video recorder) harness connector.
Remove mounting screws , and remove inside camera (driving video recorder) from inside camera bracket.
Remove mounting screws , and remove inside camera bracket ...
Hydraulic Layout
Front washer nozzle LH Front washer nozzle tube LH Front washer nozzle RH Front washer nozzle tube RH Front washer tube C Front washer tube B Front washer tube A Washer tank assembly : Clip ...
Inspection
SIDE RADAR IRRADIATION AREA
For side radar irradiation area, refer to the figure below.
Front bumper fascia Side radar irradiation area Reference point (R end) C 65 mm
(2.56 in) (character line) D 105 mm
(4.13 in) (character line) E 270mm
(10.63 in) (horizontal line) F 110 mm
(4.33 in) (ve ...