Nissan Armada 2025-2026 Service and Repair Manual: Inspection
WARNING:
INSPECTION BEFORE REMOVAL
Drive belt
WARNING:
Be sure to perform the this step when engine is stopped.
Check that the indicator (notch on fixed side) of drive belt auto-tensioner is within the possible use range.
NOTE:Check the drive belt auto-tensioner indication when the engine is cold.
Visually check the entire drive belt for wear, damage or crack.
If the indicator (notch on fixed side) is out of the possible use range or belt is damaged, replace drive belt.
A/C compressor belt
WARNING:
Perform this step when engine is stopped.(30 min or longer after engine is stopped)
Visually check entire drive belt for wear, damage or cracks.
Using a tensiometer and confirm belt tension or vibration frequency value.
NOTE:Before measuring, turn crankshaft pulley twice.
Measure belt
tension at "
" points. (Both side measurement are correct)
Confirm the belt tension value or the vibration frequency value. (see table below)
Belt tension Frequency 580 - 1327 N 192 - 292 Hz
INSPECTION AFTER INSTALLATION
Drive belt
Turn crankshaft pulley clockwise several times to equalize tension between each pulley, and then confirm tension of drive belt at indicator (notch on fixed side) is within the possible use range. Refer to Exploded View.
Adjustment
Refer to Drive Belt. ...
Engine Coolant
...
Other materials:
Removal and Installation
REMOVAL
Remove the back door finisher. Refer to Removal and Installation.
Remove the rear camera mounting screws , then remove the rear camera .
INSTALLATION
Install in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure.
Perform camera imag ...
Comparison of Pulling Methods
(1) HYDRAULIC RAM TYPE
In this method, the pressing force of a hydraulic ram is converted to a pulling force by a chain.
Pulling points on the body may be added easily, and there is more freedom to select the pulling direction.
The pulling direction changes during pulling.
Difficult to simultaneous ...
Inspection
INSPECTION AFTER INSTALLATION
Check for Fuel Leakage
Turn ignition switch “ON” (with the engine stopped). With fuel pressure applied to fuel piping, check that there is no fuel leakage at connection points.
NOTE:
Use mirrors for checking at points out of clear sight.
Start the engine. With engi ...
0.0056